General Rotary Tech Support Use this forum for tech questions not specific to a certain model year

help needed please

Old 10-18-09, 12:12 AM
  #1  
Full Member

Thread Starter
 
ion1rx's Avatar
 
Join Date: Jan 2006
Location: auckland
Posts: 59
Likes: 0
Received 0 Likes on 0 Posts
help needed please

ok guys

i was out driving around in my rebuilt s5 13b bridge ported turbo gt3540 bigger injectors blah blah.. has been tuned not to long ago well any ways story goes.

i took my vehicle into work to get a wof all was running fine.. have only done about 300-400k's on new set up, well i parked it up at home then 4 days later i started it up to put on the ramps to fix the things it failed for the warrant of fitness when i started it up it was throwing out alot of blue smoke that smelt like oil. I thought it may have been the 2stoke oil i was using as a premix which had maybe separated from the gas as i was running on almost empty so today i put in 10l's of new fuel to try and mix the 2storke to thin it out started it up. But it wasstill no good, still it was pouring out with a hell of a lot of smoke i keeped running it as i thought it may take a bit to clear but it didnt then i noticed a puddle of oil on the ground from near where my turbo is.. and also noticed there was a bubble of oil coming from between the rear rotor housing and center plate..

any ideas?


I pulled my turbo off today and i could feel alot of oil in my housings and in the exhaust manifold and in the intake pipe.. checked oil level and it was very low
Old 10-26-09, 05:20 AM
  #2  
Full Member
 
urquhartglen's Avatar
 
Join Date: Jul 2009
Location: ashburton new zealand
Posts: 106
Likes: 0
Received 1 Like on 1 Post
you have a blown oil seal in turbo (or turbo oil return pipe blocked)and or engine oil seal. if you have lots of oil in intake pipe id look at turbo and that bubble of oil by center plate and housing??? leak in oil gallery? you didnt say what side it was coming from
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
David Hayes
3rd Generation Specific (1993-2002)
13
09-05-22 12:45 PM
runner83
1st Gen General Discussion
16
08-26-15 05:16 PM


Thread Tools
Search this Thread
Quick Reply: help needed please



All times are GMT -5. The time now is 07:38 PM.