Has anyone had problems w/ 0 boost?
Has anyone had problems w/ 0 boost?
If so what was the problem? After I did the hose job I'm getting no boost. I triple checked all the hoses and solinoids but still can't find the problem. I removed the throttle butterflies hence I disconnected the solinoid for the double throttle and plugged up the nipples. could that be the problem?
It's never fast enough...
Joined: Feb 2001
Posts: 3,760
Likes: 3
From: Miami - Given 1st place as the POOREST city in the US as per the federal government
No, plugging up the solenoid for the Double throttle control won't have any affect on boost control. I know because I have it set up this way.
Have you visited this site yet? There is extensive information there on how to diagnose the entire boost control system.
http://www.scuderiaciriani.com/rx7/how-to_turbos.html
Have you visited this site yet? There is extensive information there on how to diagnose the entire boost control system.
http://www.scuderiaciriani.com/rx7/how-to_turbos.html
I would check that you don't have a hose loose causing a bad leak. these are sometimes very hard to find. I have chased this problem before. make sure all hoses are on straight and are tight.
It is odd that you have no boost at all. Does it feel like there is on power by the seat of the pants? If it was a small hose that was not connected you would still have some boost it would just bleed off fast I think. Does the boost guage show vacuum?
Kevin
Kevin
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
Mar 15, 2022 12:04 PM
Adaptronic Cranking fuel table messed up?
sherff
Adaptronic Engine Mgmt - AUS
5
Sep 12, 2015 12:22 PM
AXA
Single Turbo RX-7's
8
Sep 5, 2015 10:06 AM
tiger18
3rd Generation Specific (1993-2002)
9
Sep 3, 2015 08:27 PM



