got the fuel rail out... can't get the PD off
03-20-05, 12:28 PM
#1
Full Member
Thread Starter
Join Date: Jun 2004
Location: MD
Posts: 247
Likes: 0
Received 0 Likes
on
0 Posts
got the fuel rail out... can't get the PD off
Well i got the primary fuel out and can't seem to get the pulsation damper off.
It's screwed in pretty tight
I tried to heat it up w/butane torch and then i heard this small pop and smoke flowed out of the rail. I'm assuming the diaphragm was fine and I just exploded it?
Well is there an easier way to take the damper off? I've been trying w/a huge vice grip....
It's screwed in pretty tight
I tried to heat it up w/butane torch and then i heard this small pop and smoke flowed out of the rail. I'm assuming the diaphragm was fine and I just exploded it?
Well is there an easier way to take the damper off? I've been trying w/a huge vice grip....
03-22-05, 06:18 PM
#3
Full Member
Join Date: Sep 2004
Location: Spokane, Wa
Posts: 181
Likes: 0
Received 0 Likes
on
0 Posts
if all else fails, just use c4...
when i pulled mine i just but in a vise really tight, used a screwdriver and put all of your weight into it and eventually the screws will come out...
when i pulled mine i just but in a vise really tight, used a screwdriver and put all of your weight into it and eventually the screws will come out...
