first time rebuilder?
#1
The thing
Thread Starter
first time rebuilder?
OK here goes Im rebiulding and 87 t2 motor for my 84 se. Im going to be porting it using a RB template. I was looking at the plates as I was getting ready to start I realized that the ports in the center plate are way smaller that those in the two end plates. My question stupid as it may be is, do you port all 4 faces of the plates to the same template or are the ports in the center plate left alone or ported to a different size?
I lined the template up on both the side and center plate and it just seemed like a lot of metal to be removed.
I lined the template up on both the side and center plate and it just seemed like a lot of metal to be removed.
Thread
Thread Starter
Forum
Replies
Last Post
ncds_fc
New Member RX-7 Technical
1
08-15-15 10:06 AM