FD has been sitting for 6 years.
#1
Full Member
Thread Starter
iTrader: (3)
Join Date: Oct 2005
Location: Panama City, FL
Posts: 109
Likes: 0
Received 0 Likes
on
0 Posts
FD has been sitting for 6 years.
I just bought an FD that has been sitting for 6 years. The when they tried to start it they had to hook up a fuel pump from a bottle to get it started. Once started it appears that it lacked commpression to the rear rotor. WTF? Could it be something other than a blown seal?
#2
El Mas Tiguere...DR
Join Date: Sep 2007
Location: Big Red Country
Posts: 260
Likes: 0
Received 0 Likes
on
0 Posts
low compression needs rebuild to fix no way around it.. but if its a new engine it could just need to build compression..but you said its been sittin for 6 yrs so i doubt that.. so most likely will need a rebuild but put some oil in the plug holes and crank! but what were the compression #'s? was it on a piston tester?
#3
Rotary Enthusiast
iTrader: (5)
i'd put some seafoam in the engine first
oil that has been sitting for 6 years will turn into straight carbon and form a layer around the housing causing it to "appear" to have low compression when started
when you put the seafoam in it will clear all that collected carbon out and the compression should start to get better provided that it the problem
oil that has been sitting for 6 years will turn into straight carbon and form a layer around the housing causing it to "appear" to have low compression when started
when you put the seafoam in it will clear all that collected carbon out and the compression should start to get better provided that it the problem
Thread
Thread Starter
Forum
Replies
Last Post
HalifaxFD
Canadian Forum
126
05-09-16 07:06 PM
The1Sun
1st Generation Specific (1979-1985)
0
09-07-15 10:21 PM