I had a fuel leak under the intake runners so i replaced the fuel line and while i was at it i replaced some vacuum lines that were hardened. put it all back together and it would start at first but when you hit the gas it would die, now it wont start at all. Yes, i triple checked the vac line routing, its just like it was when i started. I do have a plug that im not sure if it was connected to something or not. It comes out of the engine wiring harness directly behind the water neck, the wire is green ( single wire) with a black plug. If someone can tell me where this goes, if at all, i would be quit thankfull.

 

help......

 

o.k. it was flooded, dried it out and it will start. but when you hit the gas it still dies. ????? any ideas????

 

repost this in the 2nd gen forum