Autometer electronic water temp gauge
Thread Starter
Junior Member
Joined: Jun 2001
Posts: 39
Likes: 0
From: sunnyvale, Ca. USA
Autometer electronic water temp gauge
I just want to know the best location to insert the thermostat in? Is there a particular place i can drill, or even better, can i just screw it in somewhere that's already pre-threaded. thanks a lot for you help.
Vagina Junction
Joined: Mar 2001
Posts: 1,838
Likes: 0
From: Seattle, WA
If you mean "sensor", which i think you do....
Best place is obviously the block, but few people are motivated enough to do this.
Next best I'd say would be the thermostat housing beneath the filler cap.
Third best would be to 'T' it into the hose next to the throttle body.
Finally, any other place you can find would be a *bad* choice, namely the AST.
~Tom
Best place is obviously the block, but few people are motivated enough to do this.
Next best I'd say would be the thermostat housing beneath the filler cap.
Third best would be to 'T' it into the hose next to the throttle body.
Finally, any other place you can find would be a *bad* choice, namely the AST.
~Tom
Thread
Thread Starter
Forum
Replies
Last Post
[For Sale] Scratch & Dent, Used, and Open-Box Sale!
SakeBomb Garage
Vendor Classifieds
5
Aug 9, 2018 05:54 PM
Adaptronic Cranking fuel table messed up?
sherff
Adaptronic Engine Mgmt - AUS
5
Sep 12, 2015 12:22 PM