automatic to manual...?
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Nov 2007
Location: Englewood/Dayton Ohio
Posts: 517
Likes: 0
Received 0 Likes
on
0 Posts
automatic to manual...?
how hard is it to swap an auto with a manual tranny? found a nice rx7 its automatic. planning on buying a complete turbo swap with 5 sped tranny. how hard would it be to switch the two?
#2
Open up! Search Warrant!
Join Date: May 2002
Location: Kicking down doors in a neighborhood near you
Posts: 3,838
Likes: 0
Received 2 Likes
on
2 Posts
My RX-7 was an auto and I swapped it to a 5 speed a few years ago. Its hard to answer your question as to how hard it was. For me, it wasn't hard. I had the right tools and I was an aircraft mechanic for 9 years so I was comfortable doing it. If you don't have the right tools then it could be harder. You didn't mention in your post what year car you are talking about but I'm assuming by your picture that its a 2nd generation RX-7. Go to the 2nd Gen section of this web site. There is an instruction thread saved in the archives. It pretty much list all the parts you need and all the tools you'll need.
Here is the link. https://www.rx7club.com/2nd-gen-archive-72/complete-automatic-manual-conversion-write-up-201102/
Also, you can go to www.rotaryresurrection.com and select the 2nd gen section. Then, click the TECH tab at the top right. Scroll down until you see the article for automatic to 5 speed conversion.
Hope that helps
Here is the link. https://www.rx7club.com/2nd-gen-archive-72/complete-automatic-manual-conversion-write-up-201102/
Also, you can go to www.rotaryresurrection.com and select the 2nd gen section. Then, click the TECH tab at the top right. Scroll down until you see the article for automatic to 5 speed conversion.
Hope that helps
Thread
Thread Starter
Forum
Replies
Last Post