20b short crank stat gear
#1
Junior Member
Thread Starter
20b short crank stat gear
Hello.
i am chasing as much info as i can about the stationary gear modification on the center iron.
and if anyone could help would be great.
i am chasing as much info as i can about the stationary gear modification on the center iron.
and if anyone could help would be great.
The following users liked this post:
Magicshoes (11-16-19)
#3
Junior Member
Thread Starter
#5
Junior Member
Thread Starter
Trending Topics
#8
Junior Member
Thread Starter
#11
Mad Man
iTrader: (5)
I was trying to figure that out actually was planning on providing direct oil feed but couldn't figure out how that would work with the cutouts the way they are.
Basic drawings for the gear modification and gear carrier as well as SW models are below. BEWARE these are in progress and not complete and were only measured with calipers.
https://drive.google.com/open?id=1_q...B287RSpGxnN1Hx
Basic drawings for the gear modification and gear carrier as well as SW models are below. BEWARE these are in progress and not complete and were only measured with calipers.
https://drive.google.com/open?id=1_q...B287RSpGxnN1Hx
#12
Junior Member
Thread Starter
I was trying to figure that out actually was planning on providing direct oil feed but couldn't figure out how that would work with the cutouts the way they are.
Basic drawings for the gear modification and gear carrier as well as SW models are below. BEWARE these are in progress and not complete and were only measured with calipers.
https://drive.google.com/open?id=1_q...B287RSpGxnN1Hx
Basic drawings for the gear modification and gear carrier as well as SW models are below. BEWARE these are in progress and not complete and were only measured with calipers.
https://drive.google.com/open?id=1_q...B287RSpGxnN1Hx
Also is this a front stationary machined down? Or something else?
#14
Junior Member
Thread Starter
#15
Mad Man
iTrader: (5)
Yeah was looking at that as well. My worry being the sealing to the gear. Leaks could drive massive pressure drops.
https://www.rx7club.com/build-thread.../#post10916266
https://www.rx7club.com/build-thread.../#post10916266
#16
Junior Member
Thread Starter
Yeah was looking at that as well. My worry being the sealing to the gear. Leaks could drive massive pressure drops.
https://www.rx7club.com/build-thread.../#post10916266
https://www.rx7club.com/build-thread.../#post10916266
Last edited by Magicshoes; 11-23-19 at 01:23 PM.
Thread
Thread Starter
Forum
Replies
Last Post