13b running problem
#1
Newbie
Thread Starter
Join Date: May 2003
Location: Cary, North Carolina
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
13b running problem
I installed a used 13B, in a 86 RX7, the previous engine died a horrible death, after the installation, the engine would turnover but would not start, checked fuel pressure, crank position sensor, & the normal things.
put noids on the injectors & found that I was not getting power, however I can spray gas directly into the intake and the car will run as long as I am spraying..
Can someone give me help ??? Thanks
put noids on the injectors & found that I was not getting power, however I can spray gas directly into the intake and the car will run as long as I am spraying..
Can someone give me help ??? Thanks
#2
Open up! Search Warrant!
Join Date: May 2002
Location: Kicking down doors in a neighborhood near you
Posts: 3,838
Likes: 0
Received 2 Likes
on
2 Posts
Which injectors did you check? The two that are on the manifold are the secondary injectors and they don't come on until your ECU senses that the engine is under heavy load. The primary injectors are the only ones that are working 100% of the time and they are right on top of the block. You have to remove the intake to get to them.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
KAL797
Test Area 51
0
08-11-15 03:47 PM