13b & 13bT housings.?
09-15-05, 02:51 AM
#1
D.I.L.U.S.I.
Thread Starter
iTrader: (5)
Join Date: Nov 2002
Location: L-Town pa
Posts: 2,051
Likes: 0
Received 0 Likes
on
0 Posts
13b & 13bT housings.?
im looking for a rear housing for my rebuild and i can get a near new housing but if from a 88 NA 13b. could this be used with the S4 13bt
Last edited by full-cruise; 09-15-05 at 02:52 AM. Reason: mis spellled
09-15-05, 12:02 PM
#4
https://www.rx7club.com/showthread.p...sleeve+removal I simply tack weld a bead on top of the spring pin and pull them out with a pair of plyers grind the bead off and they are reuseable.
09-17-05, 07:14 AM
#5
Full Member
Join Date: Sep 2005
Location: Post Falls ID
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
If your doing a stock rebuild (stock turbo and water return line)make sure water galley on the side of the housing is open and not freeze plugged.I'm sure you knew that but better safe than sorry 
Thread
Thread Starter
Forum
Replies
Last Post
