2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.
Sponsored by:

fuel injector question, how do i tell what size?

Thread Tools
 
Search this Thread
 
Old 11-29-01, 02:15 AM
  #1  
Junior Member

Thread Starter
 
Bill4224's Avatar
 
Join Date: Feb 2001
Location: CT
Posts: 26
Likes: 0
Received 0 Likes on 0 Posts
fuel injector question, how do i tell what size?

ok i have some injectors from a 90 motor 13 ohm type the part num on the side is 195500-2010
i also have some injectors from an 87 2.5 ohm type
part number 195500-1350

then i have another set of 2 injectors lieing around which i have no clue what car they came out of 2.5 ohm type
part number 195500-1370

question is does anybody know what sizes these are? i am really interested in the last type (1370).

as in ???CC

please help me out
thanks
bill

Last edited by Bill4224; 11-29-01 at 02:18 AM.
Old 11-29-01, 02:18 AM
  #2  
HyperREV.com

 
RX-7 GT's Avatar
 
Join Date: Mar 2001
Location: Oregon
Posts: 1,162
Likes: 0
Received 0 Likes on 0 Posts
if they are from a turboII they all had 550cc primaries /secondaires all years
Old 11-29-01, 02:45 AM
  #3  
I HATE sleepy eyes

 
BoostedRotors's Avatar
 
Join Date: Nov 2001
Location: Birmingham, AL
Posts: 1,180
Likes: 0
Received 0 Likes on 0 Posts
if they are maroon, they're 550cc....if they're orange, they are 680cc. hope that helps
Old 11-29-01, 02:52 AM
  #4  
Junior Member

Thread Starter
 
Bill4224's Avatar
 
Join Date: Feb 2001
Location: CT
Posts: 26
Likes: 0
Received 0 Likes on 0 Posts
ok i found the part number matching 1370 to 550cc injectors
if anyone wnated to know.
still wondering about the other 2 part numbers
Old 11-29-01, 02:59 AM
  #5  
I HATE sleepy eyes

 
BoostedRotors's Avatar
 
Join Date: Nov 2001
Location: Birmingham, AL
Posts: 1,180
Likes: 0
Received 0 Likes on 0 Posts
dont worry about the part number...go by the color.
Old 11-29-01, 03:22 AM
  #6  
Junior Member

Thread Starter
 
Bill4224's Avatar
 
Join Date: Feb 2001
Location: CT
Posts: 26
Likes: 0
Received 0 Likes on 0 Posts
ok well here are the colors

out of the 90 car = silver with ogangy/red top
out of the 87 = black with ogangy/red top
the other 2 that i'm not shure = silver with whiteish/grayish top
Old 11-29-01, 05:44 AM
  #7  
HAILERS

 
HAILERS's Avatar
 
Join Date: May 2001
Location: FORT WORTH, TEXAS,USA
Posts: 20,563
Likes: 0
Received 21 Likes on 19 Posts
I had(might still have)the same problem. I have a sack of them. The color holds no clue for me. The 1370 and 1350 were both orange as far as I'm concerned. If you know the 1370's are 550 then its almost certain that the 1350's are the 460's. Colors you say? I have some 550's that are purple. So much for color. The way I seperated the 460 from the 550's was to take the secondaries out of their bores and put a measuring cup under them and then apply 12v for a full minute. Measured the amount and seperated the 460's from the 550's. Unfortunatly they got mixed again since then. P.S. How did you determine the 1370's are 550's for sure? Know nothing about 2010's. Here's another opinion on COLORS https://www.rx7club.com/vforums/show...threadid=31937 Go figure!

Last edited by HAILERS; 11-29-01 at 05:50 AM.
Old 11-29-01, 07:31 AM
  #8  
Junior Member

 
larsyoung's Avatar
 
Join Date: Jul 2001
Location: Naples, Florida
Posts: 14
Likes: 0
Received 0 Likes on 0 Posts
195500-2010 - dunno

195500-1350 - 1986-87 non-turbo 460cc 1.5-3 ohm. Color should be brown

195500-1370 - 1986-87 turbo 550cc 1.5-3 ohm. Color should be purple.

This info came from TSB 033/87

Lars
Old 11-29-01, 07:38 AM
  #9  
r71's daddy

 
David88vert's Avatar
 
Join Date: Feb 2001
Location: Atlanta, GA
Posts: 935
Likes: 0
Received 0 Likes on 0 Posts
Lars is correct. I will look up the 2010's.
I have a RX7 injector chart, but I don't have it here at work.
Old 11-29-01, 08:47 AM
  #10  
HAILERS

 
HAILERS's Avatar
 
Join Date: May 2001
Location: FORT WORTH, TEXAS,USA
Posts: 20,563
Likes: 0
Received 21 Likes on 19 Posts
REf LARSYOUNG POST......That right there is why I don't go by color. All the injectors I have are brown to dark brown in color. The -1370's that I have are dark brown. I bought some rebuilt ones a while back from autoparts.com, and they were 550's and indeed were purple. There was no number embossed on them. If I disregard the talk about color, it makes sense to me.
Old 11-30-01, 02:42 AM
  #11  
Junior Member

 
jim_o_rama@hotmail.com's Avatar
 
Join Date: Nov 2001
Location: Montreal
Posts: 7
Likes: 0
Received 0 Likes on 0 Posts
I've got a set of 195500-2010.

They're supposed to be coming from a 2nd gen n/a(460cc).

Need to verification.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
82streetracer
1st Generation Specific (1979-1985)
7
08-23-15 09:28 AM
86rxNa
2nd Generation Specific (1986-1992)
2
08-11-15 11:51 AM



Quick Reply: fuel injector question, how do i tell what size?



All times are GMT -5. The time now is 06:37 PM.