im looking to raise the rear of my car about half an inch so my new 18's fit nicely without rubbing, and i have adjustable cusco coilovers, these came with the car so im at a loss as how to adjust these

is there a way to lock and unlock the bottom two rings or do you literally just turn one then the other with a c-spanner??

here's a pic:

 

Ryan, lurking on here as well. What are we going to do with you!

Yes the bottom part of the springs are two plates that screw together. Clean up the bottom of the spring area, and you should be able to see that you need to loosen the top adjuster up then bring the bottom up to tighten against it.

Dan

 

indeed, was just seeing if anybody had this particular suspension, but it appears not! that tein diagram was quite clear but now at least i know now!!!

i'll figure it out now im sure

 

holy cow that thing is dirty!!! must be th UK weather. anyways yeah you gotts lossen the rings.....and then make the top ring go lower. good luck, and post some pics of that bad boy when its cleaned up....kinda like a before and after pic

 

lol they are a bit dirty arent they!!! i power hosed them today so they're a lot cleaner now!!! i'll take another pic

 

well i got them cleaned up best i could with a hope and brush, at least i can see what im doing now

 

Thats it, How far up did you put the platform?

Dan

 

i havent yet, i dont have a c-spanner, as you can see from the chips i had a go with a wrench but it wasnt budging so gonna have to make a few trips and get myself one

it literally needs going up half and inch, all this bother for that much lol

 

i wonder if someone you know or maybe a local speedshop will have the tool you need. i would try one of those places before i would buy one. my friend works at a local tuner shop and he said they usually have them laying around

 

Ryan, I will try and find one tomorrow for you. I gotta get some for myself.

Dan