Marcel Burkett

Hi all , I am going to attempt to fabricate a custom upper manifold for a PP motor I'm building . I have checked all over the internet but I cannot find what I want to use ,namely a pair of long radius schedule 40 aluminum elbows and a pair of 3" I.D. velocity stacks , can anyone direct me to a source for these ? I plan on using the "D" shaped plenum material from Ross Machine.

Marcel Burkett

Anyone ???

TeamRX8

iTrader: (2)

maybe be more specific, by long radius do you mean 8" or 36"? You also did not make it clear what diameter you want for them, are we to assume 3" based on your latter comment? I don't know where you will get a 3" ID air horn since most are based on tubing OD sizes. A 3.5" bellmouth from Vibrant has about a 3.25" ID. If you're going to tie it into a 3" sch. 40 pipe fitting then it will have enough thickness to grind-blend it in.

http://www.globaltecheng.com/product...=0&VS3=0&VS6=0


surprised these aren't listed

http://www.spdexhaust.com/

http://www.coastfab.com/

.

TeamRX8

iTrader: (2)

tripped across this recently, good stuff here for the most exotic exhaust system you can imagine

http://www.reidwashbon.com/

TeamRX8

iTrader: (2)

Another high end exhaust component source, based in the UK but has a location in NASCAR country

http://www.goodfabs.com/

Zacho

I'm really surprised this place hasn't been mentioned yet. I've probably ordered a few thousand worth of supplies from them by now. Always good & easy to deal with even though I'm in Canada.

Ace Stainless

blackgunsalute

Great stuff thanks