i know this should be in the PFC forum but theres more traffic flow here as im am installing my PFC.
i know u disconnect the stock ecu and plug it into the PFC. but i hear that theres some wires u have to cut or splice.

 

don't cut the wires.. too much of a PITA. get some pliers and work the respective Pins off the power FC. I forget which ones they are. hopefully someone else will have that info for you.

 

so bascally i have to pull some pins out? i just went for a drive and didnt pull the pins out. but just cruzing didnt WOT the sucker, even tho i was so temped too.

does ne one know what pins i have to pull out? also where do u check the air fuel ratio and the fan mod?

 

anyone just leave the wires alone, i did and it runs fine??