Tachometer input wiring for 3rd Gen
Thread Starter
Full Member
Joined: Mar 2001
Posts: 72
Likes: 0
From: SoCal
Tachometer input wiring for 3rd Gen
For those of you that are using a stand alone
ECU that has an output to the tachometer, where is the tachometer input wire? Is it
located in one of those X-connectors or
did it went straight to the dash? Which wire?
I seem to have problem finding the input wire to the tach in my 1995 manual.
Thanks!
ECU that has an output to the tachometer, where is the tachometer input wire? Is it
located in one of those X-connectors or
did it went straight to the dash? Which wire?
I seem to have problem finding the input wire to the tach in my 1995 manual.
Thanks!
Haltech E6K
Joined: Feb 2001
Posts: 420
Likes: 0
From: Northern California (USA)
Check my webpage under Haltech E6K info. I do not remember off the top of my head, but it is listed under the wiring diagram.
------------------
<A HREF="http://ricemobile.net/" TARGET=_blank>
</A>
Jay
The Ricemobile
94 Base w/ never enough mods
87 Base w/ never enough miles
------------------
<A HREF="http://ricemobile.net/" TARGET=_blank>
</A>Jay
The Ricemobile
94 Base w/ never enough mods
87 Base w/ never enough miles
Haltech E6K
Joined: Feb 2001
Posts: 420
Likes: 0
From: Northern California (USA)
Making okay progress. Hopefully I will have some good pictures up next week.
Jay http://ricemobile.net/ (newly redesigned)
Jay http://ricemobile.net/ (newly redesigned)
Thread
Thread Starter
Forum
Replies
Last Post
troym55
3rd Generation Specific (1993-2002)
23
May 25, 2016 12:42 PM
