Plug for Dizzy/CAS Hole?
Thread Starter
Rotary Enthusiast
Joined: Oct 2001
Posts: 1,022
Likes: 4
From: Ontario, Canada
Plug for Dizzy/CAS Hole?
I'm running a crank-fired (ok, e-shaft-fired) ignition system in my 13B. I've discarded the distributor, and replaced it with an S4 CAS. I'd like to go the next step, and remove the CAS, and replace it with a suitable plug. I may have to machine up something to suit, but I thought I'd check and see what others have done in this instance.
Any recommendations?
Any recommendations?
Junior Member
Joined: Oct 2001
Posts: 29
Likes: 0
From: Ellicott City, Maryland
You can press fit a large enough freeze plug or just use a block-off plate with sealant and nut. I've seen it work both ways. I personally use the freeze plug. It makes for a cleaner install.
-Brad
-Brad
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic S5 Turbo PNP Unit questions
_Tones_
Adaptronic Engine Mgmt - AUS
10
May 25, 2021 05:37 AM
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
mulcryant
2nd Generation Specific (1986-1992)
10
Sep 9, 2015 05:24 PM
