Ignition Installation, ignition Output: J7
Thread Starter
Full Member
Joined: Aug 2001
Posts: 94
Likes: 0
From: N14°34'55.9" W090°30'10"
Ignition Installation, ignition Output: J7
Hi there
This is only for rx-7 3er generation model 93
Regarding the Ignition output harness supply by haltech, according to the diagram in the manual there are 6 wires to be connected to the stock ignition module.
Can anyone tell me how to wire the J7 connector to the stock ignition module. the coils with the triggers sensors?
Regards,
Bruno
This is only for rx-7 3er generation model 93
Regarding the Ignition output harness supply by haltech, according to the diagram in the manual there are 6 wires to be connected to the stock ignition module.
Can anyone tell me how to wire the J7 connector to the stock ignition module. the coils with the triggers sensors?
Regards,
Bruno
Thread
Thread Starter
Forum
Replies
Last Post