HKS PFC F-CON wiring question
04-29-09, 11:47 AM
#1
HKS obsessed
Thread Starter
iTrader: (7)
Join Date: Mar 2008
Location: OP, KS
Posts: 1,529
Likes: 0
Received 0 Likes
on
0 Posts
HKS PFC F-CON wiring question
So I bought the F-CON off here for cheap, and the harness seems pretty fucked. There's a FCD wired in, but the other three wires that were cut to solder the FCD in are just hanging there not attached to anything. And when I read this manual http://www.alltrac.net/manuals/HKSFCON.html it talks about a pressure sensor that I don't think I have with it. I'm not a huge wiring guy but the FCD is wired in shitty so I was just wondering if the best bet is to remove it and solder the wires back together? Or should I just go ahead and order a new harness, and does anyone know if the new harnesses come with the pressure sensor?
05-26-09, 04:29 AM
#2
Not Even Foo
iTrader: (13)
Join Date: Oct 2006
Location: South Bay, CA
Posts: 8,999
Likes: 0
Received 0 Likes
on
0 Posts
bump.
i actually scooped up an HKS PFC F-Con as well for the S4 TII.
have complete harness and unit.
do we have to buy that separate pressure sensor that's posted on fc3spro.com?
http://fc3spro.com/TECH/MODS/EL/FUELCON/HKS/fcon.htm
i actually scooped up an HKS PFC F-Con as well for the S4 TII.
have complete harness and unit.
do we have to buy that separate pressure sensor that's posted on fc3spro.com?
http://fc3spro.com/TECH/MODS/EL/FUELCON/HKS/fcon.htm
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM
