? Emanage ultimate
#1
? Emanage ultimate
I currently have a pettit retuned ECU in my 93 rx7. I am considering getting the Greddy Emanage ultimate.
Do I need to get a untuned ECU to use with this?
Can I keep the pettit and start from there?
The reason for cosidering this is because it seems like you get alot for the money.
Any advice would be greatly apreciated
Brandon
Do I need to get a untuned ECU to use with this?
Can I keep the pettit and start from there?
The reason for cosidering this is because it seems like you get alot for the money.
Any advice would be greatly apreciated
Brandon
#2
Senior Member
iTrader: (2)
Join Date: Apr 2001
Location: Salt Lake City, UT
Posts: 742
Likes: 0
Received 0 Likes
on
0 Posts
You can keep the tuned ECU and run the Emanage Ultimate. It will just keep the existing settings, and you can modify it from there. It does not know if the ECU is stock or reprogrammed, so it will just treat it as stock. I run the blue Emanage, but am planning on upgrading after a few bugs in the software and firmware are sorted out. I would say go for it, you will like what it can do.
#4
Senior Member
iTrader: (2)
Join Date: Apr 2001
Location: Salt Lake City, UT
Posts: 742
Likes: 0
Received 0 Likes
on
0 Posts
I don't see why not. I'm not sure what the ECU is dependent on with the stock turbos, but I would think it would not effect your AFR or timing. It may throw some error codes at you, but then again not sure. I'm running the blue emanage on my FC, my FD is pretty much stock.
#5
Rotary Enthusiast
iTrader: (31)
Originally Posted by oorx7
Now for another question. I should be able to convert to single with the emanege, Right
yes you can, i run a t04r on a G-force ecu with PFS purple box@ 11 psi. so with the emanage, you should be alright.
Im getting to its limits, so i got an AEM EMS.
Good luck
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM