2nd gen need power
Thread Starter
Junior Member
Joined: May 2001
Posts: 9
Likes: 0
From: Huntsville, AL
2nd gen need power
ok, I don't know to much about the hole computer/ecu area. But i am lookin for where to start. I have done just about all the normal mods: exhaust, K&N filter charger, fuel pump. but i want some real power increase, only have about 15k miles on this motor. Will get the next motor ported, but not going to pull this one. Any help on where to start for computer upgrade or a complete new control system. I'm not to worried about cost. Please any help would be appriciated!
Full Member
Joined: Jul 2001
Posts: 86
Likes: 0
From: Cincinnati/N.KY.
Easy there big guy, a little more info would be helpful. It appears you have a NA(normally aspirated) car. There are quite a few things you can do for added power but confirming whether it is a turbo or not would help.
Rotary Enthusiast
Joined: Apr 2001
Posts: 1,289
Likes: 0
From: North Hollywood, Ca USA
ECU or complete aftermarket engine management is not going to give you any large gains in power. for the N/A you will need to do some porting to get any large increases in power. after the porting the a nice free flowing exhaust and intake them maybe think abou the ECU upgrade. or maybe check into some of the supercharger and low pressure turbo upgrades. nothing easy for the N/A sorry.
Thread
Thread Starter
Forum
Replies
Last Post