Roxanne: ksnew's fd3s build thread.
#165
Decided to make my other gauge pod less ghetto. Still haven't finished it, but here's the progress so far.
First I used expandable foam and shaped it back to the contour of the dash. Then I used spray adhesive and put a piece of fleece down to start the base of the gauge pod.
Then cut off the excess.
Applied resin
started shaping it once dried
cut out the shape of the gauge pod, and fiberglassed it in.
Just been shaping it the past day or so, hopefully I'll get it finished on my day off. then time to wrap it, or paint it, still haven't decided which to do.
First I used expandable foam and shaped it back to the contour of the dash. Then I used spray adhesive and put a piece of fleece down to start the base of the gauge pod.
Then cut off the excess.
Applied resin
started shaping it once dried
cut out the shape of the gauge pod, and fiberglassed it in.
Just been shaping it the past day or so, hopefully I'll get it finished on my day off. then time to wrap it, or paint it, still haven't decided which to do.
#166
well, harness is plugged in, ready to go, drained the old gas, double checked the pin out from where I re-pinned the harness, and plugged in the pcm. as long as all goes as planned, I should be starting this turd up for the first time in nearly two years!
#174
I couldn't run the abs wheel sensors in the rear anyways since they can't be ran with the dual brake caliper kit, my abs harness was messed up from my wheel rubbing through the connector in the wheel well so it didn't work anyways, and because it give me more space in the engine bay at the back of the motor and on the passenger side.