No, it's just so simple, easy, fast and ghetto it MUST not work properly....... I love car forums.

I bet if you used one of those gold Sacajawea dollar coins people would be all over this ****.

BLING!




That's not a bad idea but alas, it wont fit.

 

that baby looks like the thing growing out of that dudes chest on total recall.

 

Quade! Open your mind!

 

yah and that chick with 3 ***** in that MESSED UP BAR. nuge

 

works on 240s as well good write up thanks

 

 

It does look like that baby haha

 

i know my sifi, got that mess on vhs, snookans!

 

this **** is ******* awesome

 

yup should of never shut off those fans

 

You know what I do? best of both worlds. Duct tape a penny on the top of the button for the event, and then take the duct tape off when you want to use it during the day as a parking break.

 

penny in the handdle alows you to use your ebreak, and duct tape could slip off

 

duct tape makes the handle sticky. i made my own drift **** too. i work at a machine shop, so i just turned it on the lathe, and then tapped it for my ebrake. works awesome. i do like the penny mod.

 

^ got pics of your mod?

 

ya could i get one

 

hmm. i could probably pull off something. whats your thread pitch, i drive an is300 so mine might be different. i can take pics tomorrow if you like, but i'm not going outside tonight.

 

no rush. thanks

 

Penny wasn't working out to well. My handle has some plastic thing in the end and that along with the penny went flying messing with it (going to have some fun in the next hour or so after i remove lo.se items from the car and gas up). I took a pedal cap that fell off my bike and jammed it in there. Problem solved. I'll do a write up in this thread just incase you guys have the same style handle i do and want to be a cheap ***.

 

my drift ****. plain aluminum. threaded for my IS300, and turned down to the size of my button hole on the lever.

 

That's pretty trick.

Used lathes are rather cheap if you buy manual ones. Hell even new ones from china are cheap....probably not as durable but i want one so i can make cool trinkets like that.

Anyway here's my gay ****.



See bmx bike? See fc? Good. Lets combine and happy.



Technically any 9/16" spindle pedals should work. I didn't take a picture of the cap itself but it's got a ridge that fits inside the pedal and a recess to keep it locked in there. Mine fell out of the other pedal because i do pedal grinds.... A flathead or pick usually works to get these out.



Push it in. It's a bit of a smaller bore then the pedal it's suppose to fit in so it wont fly out. I took this halfway into beating it onto the handle with a hammer. Lol. It's not cool, clean, smooth or anything but it gets the job done no frills.