compressor map question
#1
Junior Member
Thread Starter
Join Date: May 2012
Location: San Angelo, Tx.
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
compressor map question
I am sorting out which turbo I'm going to use and I am looking at the compressor map for the s363. I know about how many lbs/min I want to be at, but how do I know where to plot pressure ratio? How much will the plot change based on turbine aspect ratio, or does that not relate? Is there a rule of thumb on efficiency percentage not to drop under for pump gas cars with no water/meth?
#3
1308ccs of awesome
iTrader: (9)
FC3S Pro v2.0:  Turbo Tech - Compressor Maps
the pressure ratio is how much boost you want to run starting from a complete vacuum
1 = 0 psi
2 = 14.7 psi
3 = 29.4 psi
turbine doesn't affect the compressor map because it's unrelated to how efficient the compressor side is.
the pressure ratio is how much boost you want to run starting from a complete vacuum
1 = 0 psi
2 = 14.7 psi
3 = 29.4 psi
turbine doesn't affect the compressor map because it's unrelated to how efficient the compressor side is.
Thread
Thread Starter
Forum
Replies
Last Post
rx8volks
Canadian Forum
0
09-01-15 11:02 PM