snap hub starter?
11-23-11, 11:34 AM
#1
What am I doing...
Thread Starter
iTrader: (2)
Join Date: Jul 2009
Location: Toronto
Posts: 481
Likes: 0
Received 0 Likes
on
0 Posts
snap hub starter?
anyone know if this is real, im talking about the snap hub that starts the car. and if it does where can i get one lol.
video is from speed master, shows it at 40sec
http://www.youtube.com/watch?v=ZyBxlBIKKqQ
video is from speed master, shows it at 40sec
http://www.youtube.com/watch?v=ZyBxlBIKKqQ
11-23-11, 12:43 PM
#5
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
that NRG hub is just a regular hub.
did you not see when he attached and spun the steering wheel that the car started up?
That is SO cool!!!..I want one TOO!.
did you not see when he attached and spun the steering wheel that the car started up?
That is SO cool!!!..I want one TOO!.
Trending Topics
11-24-11, 04:17 PM
#8
What am I doing...
Thread Starter
iTrader: (2)
Join Date: Jul 2009
Location: Toronto
Posts: 481
Likes: 0
Received 0 Likes
on
0 Posts
haha nice
if i cant find one i might just mod a normal one with 2 extra contacts. then make a small circuit board and program it to engage the starter and ac position, take the rpm signal and after 500rpm(when crank fueling ends) release it. but not re-engage until ac has been turned off, ether by taking the wheel off or hitting a hidden but conveniently placed reset switch.
sounds like it should work.
if i cant find one i might just mod a normal one with 2 extra contacts. then make a small circuit board and program it to engage the starter and ac position, take the rpm signal and after 500rpm(when crank fueling ends) release it. but not re-engage until ac has been turned off, ether by taking the wheel off or hitting a hidden but conveniently placed reset switch.
sounds like it should work.
11-25-11, 11:19 AM
#14
What am I doing...
Thread Starter
iTrader: (2)
Join Date: Jul 2009
Location: Toronto
Posts: 481
Likes: 0
Received 0 Likes
on
0 Posts
in the comments for that video someone said that its a d1 spec quick release and that they had one on there mr2. i cant find ony videos on one working though.
11-25-11, 03:15 PM
#15
4th string e-armchair QB
iTrader: (11)
Join Date: May 2005
Location: North Bay, Ontario
Posts: 2,745
Likes: 0
Received 0 Likes
on
0 Posts
Any quick release can be spun like that I thought, I have the Bell quick release and if I remember (it's been a while sadly) you can snap it on in any position, but it rotates until it is centered then locks into position. It's getting it to crank until started that would be the trick, especially on a rotary. lol
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM
