Christopher W.

iTrader: (2)

I might of found some S4 Upper B-Pillar covers from a manual seatbelt car. Are the S4 and S5 Upper B-Pillar covers the same?

rx7racerca

iTrader: (1)

I think they are on Canadian cars, but not on US cars (motorized mouse belts on the S5's in the US). Do a search in the 2nd Gen forum archives, I'm pretty sure I've seen this question before. It might even be in the FAQ's

Christopher W.

iTrader: (2)

I have searched....all I found out about is the convertibles.

I have removed my auto seatbelt mechanisms. All I need to finish up is the upper b-pillar covers. I can at least broaden my search if I can also look for S4 pillar covers.
My car is a S5.

rx7racerca

iTrader: (1)

Found some threads on this. The short answer - no, they're not the same, but they are interchangeable. If you've removed your mouse-belts, the S4 pieces, or S5 pieces off a Canadian car will work, all the attachment points are there and the same, but it sounds like you might need to drill out the upper seat belt mounting point. I presume you're looking for S4 to get a more finished look, without the gap of the old mouse track?

https://www.rx7club.com/showthread.p...=b-pillar+trim
https://www.rx7club.com/showthread.p...=b-pillar+trim
https://www.rx7club.com/showthread.p...=b-pillar+trim

these are just a few threads - read down through them, none had good answers right at the top of the thread.

Christopher W.

iTrader: (2)

Good stuff...thanks for your effort. This search engine is very lacking. I was just looking and it said there are no responses for the word, "interior," in the 2nd gen F/S parts section.

Anyway, I am going with straight street harnesses. I have completely removed all of my seatbelts and mechanisms. So, all I am trying to do is get something to cover my upper b-pillars with. I already have manual seatbelt lower b-pillar covers. Looks like I can get S4 or S5.

Thanks again,
C