Need a Favour from a FB guy.
#1
400WHP or bust
Thread Starter
iTrader: (7)
Join Date: Oct 2003
Location: Walkerton, Ontario Canada
Posts: 4,048
Likes: 0
Received 0 Likes
on
0 Posts
Need a Favour from a FB guy.
i need the height of your motor mounts, when they are compressed. i'm making some solid ones and i'm pretty sure the FB ones are much shorter then my FC ones.
need the measurement from the metal cup, to the bottom of the rubber.
Thanks
Kevin
need the measurement from the metal cup, to the bottom of the rubber.
Thanks
Kevin
#2
Certified Old Fart
Join Date: Oct 2004
Location: Inkerman, On, South of Ottawa, the 2nd coldest Capital in the World
Posts: 490
Likes: 0
Received 0 Likes
on
0 Posts
Measurement for you
I had the undertray off to do some work under there, so I measured the passenger side mount for you.
Not counting the thickness of the cup itself (around 1/8") the gap used by the rubber amounts to exactly 1 1/4".
I need to qualify this with two bits of info:
1: I have a GSL-SE so these are 13b measurements.
2: The mount doesn't sit exactly square. The gap is slightly bigger at the top side and slightly tighter at the bottom. The total difference is 1/8" or less.
Providing the extra info because I don't know just how exact you want to be...
Good luck.
Rob
Not counting the thickness of the cup itself (around 1/8") the gap used by the rubber amounts to exactly 1 1/4".
I need to qualify this with two bits of info:
1: I have a GSL-SE so these are 13b measurements.
2: The mount doesn't sit exactly square. The gap is slightly bigger at the top side and slightly tighter at the bottom. The total difference is 1/8" or less.
Providing the extra info because I don't know just how exact you want to be...
Good luck.
Rob
Last edited by Whanrow; 04-20-05 at 09:54 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Kruel13
1st Generation Specific (1979-1985)
24
09-16-15 09:08 AM
madscientist
2nd Generation Specific (1986-1992)
1
05-30-03 09:41 AM