Let the widebody cosmo vert project begin!!!
well no huge progress this week but a few things added/modded. I finally got my fuel rails made so I thought i would be a good time to get the fuel system going,. I have a walbro 255 in tank pump and a unknown, however i think it's and aeromotive 2nd pump, so I have two feeds comming up from the tank going into one around the engine and a paxton FPR to finish off the line, rails will be going in next week once i get some an fittings. I got the 3" exhaust in and its a tight squeeze on the rear bumper, probablly going to have to open up the holes a touch before i melt the crap out of it. The wheel spacers i got with the car weren't exactly right on the car so i had to have 2 front ones made a little wider than the originals and the 2 rears were shaved down about 3/4", alternator is in and getting the motor ready to fire up for the first time in 3 years. Here are some pics of the progress.
Looks sweet. What are you using for a fuel door solution with the wide body? I have some Extreme Dimension wide rear fenders to install and I can't figure out what I'm supposed to do about the fuel door.
Yep. I think I paid $275 for that piece plus it is very hard to find fuel line large enough to make an extension. I ended up buying the line from a specialty store that wanted something like $30 per ft.
Thread
Thread Starter
Forum
Replies
Last Post
Donald Hampton
2nd Generation Specific (1986-1992)
16
Nov 23, 2022 06:38 PM







