Hey guys, me and Smitter are doing my engine install, and its all ready to be put in today, but we are out of a Hoist! So hey, if any one in Calgary has a Engine Hoist Id love to take it off your hands, and if you would be willing to help, that would be awesome! Food and Drinks on me! Hit me up a PM if you have a hoist and/or want to help out with the install. It could even be tonight (May10th) before its dark out. Thanks a bunch guys!

-Mark

 

BUMP need a hoist for today! May 11th!

 

c'mon boys, someones gotta have one, we just need it for a couple hours and can pick it up, we dont really need your help, just your engine hoist. Thx

 

Check Princess Auto, they are really cheap...

 

^not really looking to buy one.

 

You can just buy it and return it

 

not exactly what we have in mind. Worst case we will rent one, but there has to be some guys here willing to help out, yea?

 

I have one you can come and borrow.

 

hey Gary thanx for the offer. we got one. Syritis showed up with his.
we got the car almost ready to fire, but we found a broken wire on one of the CAS clips so we had to shut it down for the day.

 

yup! OH SO CLOSE! Damn Cory Thanks for the bloody help man, appreciated it SO MUCH! same with you Andrew lots of thanks!

 

Both great guys indeed! Heh Andrew, ya ready for another install with my car again?

 

ZLOL, that sucks, kinda like sliding into third base without protection, "DENIED ENTRY" , you'rrrre out.

 

haha exacly, lol. hahaha

 

whne i get some time i'll be ready for that motor of your gary. just try and get me as muct notice as u can b/c i know my weekends are busy but i'll always make room for a friend.

 

well sorta like that, but in that case i would make a gitchless run to the 24hr macs store, drunken or not. wouldnt be the first time.

 

Thanks Andrew. Adam has committed to a delivery date of Friday May 23. And I know he always keeps his word. Installation date (weather permitting) will be saturday May 24th so I can take her out saturday night. Going with S4 rotors this time, donated by Max. These happen to be 3mm, which combined with the tougher s4 rotors will make for a bullet proof assembly at the cost of only a few hp. Even though Adam now prefers 2mm, we are gonna use the 3mm rotors (I have budget constraints) and use Adams seals. Ground up rebuild, again, but I'll be much more careful with the tune this time . So much for experimenting with timing curves, now I'll do the experimenting on a distributor machine first!

 

Oh, and a big thanks to Adam for the prompt support with the diagnosis and rebuild! And thanks to for Max for the rotors..