just like the title says i am looking for someone in calgary who is good with fiberglass and has some time. let me know if your the god of cat hair.

 

for what? I made a dash board for my car? maybe I can help.

 

making a mold for headlights. also a three gauge pod for idiot lights.

 

something kinda like this but with three gauges.





if possible make a one piece kit that would replace the idiot light suround

what do you think guys think, some one want to help on this project?

 

if you were replacing the whole idiot light surround kinda deal It wouldnt be that hard

 

we might be able to work something out, I was wanting to make a flush light kit. I bought dltreezans kit and it seems very do able. I would almost be tempted to just make a good housing for the flash to pass lens area. put in a nice bulb and dont have the flip up motors.

Time definitly isn't something I have much of though, I would have to wait til I"m done my own car.

 

smonty i am in the same boat as you, v8 swaps a hard and trying to do it and finish up at school is even harder. i dont have much time for a whole lot for the next month but then i go to work for the summer.

i would love to get this project off the ground, i think everyone could benifit from a three gauge pod that sits low to the dash and is out of sight of the guy in the next car.

when i get some time i am going to try to make a better rough mold to work from.

 

i tought 5one5 is selling one of this 3 gauge pods that replace that idiot surround??

 

i want to keep the idiot lights

 

It really dont think it would be that hard, I have never tried to f/g something onto plastic though, only one off complete units.

this is the dash board

 

that is a sweet dash! nice work man.

i would be looking at making a one piece replacement that will keep the lights and add the gauges.

after i make a better base to work from we should meet up and work something out.

ps. how is your swap going, i would love to see it.

 

I will finish all the wiring within the week, I get my headers tomorrow and my rad brackets, I dont see it taking longer than april to drive it under its own power.