Cash to anyone who could help me out.
#1
Rotary Enthusiast
Thread Starter
iTrader: (8)
Join Date: Jan 2007
Location: Burlington, Ontario
Posts: 847
Likes: 0
Received 0 Likes
on
0 Posts
Cash to anyone who could help me out.
Where do I start? I have a 1st gen with a TII swap and Microtech ECU. I bought the engine and ECU from a guy, who also installed it for me. It has an upgraded turbo, front mount intercooler, MSD fuel pump and an aftermarket BOV. He has started it a couple of times, but if the engine shuts off it wont restart. I do not know much about the ECU, so my offer is cash to anyone in the Burlington area(Canada) who can help me out.
#2
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
try BRENT CLEMENT (on forum Here) Send him a PM..he knows about the MicroTech unit and maybe he can help you out.he is located In INNISFIL,which is inbetween Toronto And Barrie..Good luck!STYX.
#3
(blank)
iTrader: (1)
Is it flooding? You may get more help (although not necessarily local) in the 2nd gen section or in the Engine management section. Try the regular and severely flooded proceedures and then restart. I'm a noob when it comes to engine management systems, but it sounds like it's set a bit too rich under the parameters for starting/warming up.
Thread
Thread Starter
Forum
Replies
Last Post
FC3S Timmy
2nd Generation Specific (1986-1992)
16
10-03-15 01:08 AM