CAS timing
04-14-11, 11:50 PM
#1
CAS timing
so i have an aftermarket pulley and no indication of any notches on it and i have to get the timing correct on the engine before i start it....im searching all over and everyone says yellow notch blah blah....is there no other way to do this properly??
HELP please!
HELP please!
04-15-11, 09:56 AM
#2
what after market pulley do you have ?
mazdaspeed , mazdaracing racing beat ?
take a picture of it. Worse comes to worse order a double sheeve Racing beat pulley ( $ 78 US ).
you can find top dead center and make a mark. But IF the pulley is a random pooper, then buy something to get solid markings. Not worth blowing a motor for a few bucks.
And im assuming you have a , S4, S5 or RE motor.
mazdaspeed , mazdaracing racing beat ?
take a picture of it. Worse comes to worse order a double sheeve Racing beat pulley ( $ 78 US ).
you can find top dead center and make a mark. But IF the pulley is a random pooper, then buy something to get solid markings. Not worth blowing a motor for a few bucks.
And im assuming you have a , S4, S5 or RE motor.
Thread
Thread Starter
Forum
Replies
Last Post
stickmantijuana
Engine Management Forum
11
11-09-15 01:15 PM
stickmantijuana
MoTeC
5
09-10-15 07:58 PM
