Air Temp sensor thread size
#1
Air Temp sensor thread size
Anyone know the thread size of an air temp sensor from a series 4/5 turbo motor?
I used my stock GSL SE sensor in my project car. The sensor broke somehow & Mazda has discontinued it (found out today). The thread size for this sensor is 1/8" NPT.
Thanks
I used my stock GSL SE sensor in my project car. The sensor broke somehow & Mazda has discontinued it (found out today). The thread size for this sensor is 1/8" NPT.
Thanks
#2
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
As I recall it's M11 x 1.0. Very close to 1/8" NPS, but not quite.
And just FYI, if you use that sensor and find your Microtech is reading temperature all wrong, it means that the Microtech left the factory calibrated for a difference sensor (most often GM). Seems to be a common occurrence. Just in case I suggest adding a 3/8" NPT bung on your plenum while it's convenient.
And just FYI, if you use that sensor and find your Microtech is reading temperature all wrong, it means that the Microtech left the factory calibrated for a difference sensor (most often GM). Seems to be a common occurrence. Just in case I suggest adding a 3/8" NPT bung on your plenum while it's convenient.
Thread
Thread Starter
Forum
Replies
Last Post
immanuel__7
2nd Generation Specific (1986-1992)
89
09-05-15 10:23 AM
befarrer
Microtech
3
08-22-15 05:52 PM