91 fc engine bay rebuild
#26
FNG **/
Thread Starter
iTrader: (1)
Join Date: Jul 2013
Location: FLLLLOOOORIDAAAAAA
Posts: 27
Likes: 0
Received 0 Likes
on
0 Posts
So to let you all know, most of the parts listed are not even close to what i had to get. And the build was set for November with was setback due to the delivery of the engine. I keep getting advice after the point i needed it. everything is bought. All for the intake manifold in which im looking for a 4 port from a fc or fd, that seems nonexistent. When im done Ill post up what i did and what i got.
#27
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
I hope you didn't even think about that Turbo.
it's JUNK.
I wouldn't put it on a lawnmower.
If you look at Masterpower T70,they are cheap and some guys have had decent luck with them.They are cheap and do the job.
it's JUNK.
I wouldn't put it on a lawnmower.
If you look at Masterpower T70,they are cheap and some guys have had decent luck with them.They are cheap and do the job.
#29
★*NGTDRV★*
iTrader: (16)
And the build was set for November with was setback due to the delivery of the engine. I keep getting advice after the point i needed it.
everything is bought. All for the intake manifold in which im looking for a 4 port from a fc or fd, that seems nonexistent. When im done Ill post up what i did and what i got.
Thread
Thread Starter
Forum
Replies
Last Post
immanuel__7
2nd Generation Specific (1986-1992)
89
09-05-15 10:23 AM