My 93 Mazda Rx7 Touring
#1
Can Post Only in New Member Section
Thread Starter
Join Date: Feb 2016
Location: Irving Tx
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
My 93 Mazda Rx7 Touring
My setup 😉
Buffing complete
First day at the shop 🤕
This is my very first FD rotary I ever owned. Bought it off from an auction and fixed her myself. Made it a 2-tone black and red with velocity pearl all over. Motor has been build by Banzai Racing 13b-REW single conversion, 2mm super seals and a street port. Emissions has been deleted as well as the air pump pulley. I'm running on Low boost .7 bar at 331 to the wheel.
Buffing complete
First day at the shop 🤕
This is my very first FD rotary I ever owned. Bought it off from an auction and fixed her myself. Made it a 2-tone black and red with velocity pearl all over. Motor has been build by Banzai Racing 13b-REW single conversion, 2mm super seals and a street port. Emissions has been deleted as well as the air pump pulley. I'm running on Low boost .7 bar at 331 to the wheel.
#3
Can Post Only in New Member Section
Thread Starter
Join Date: Feb 2016
Location: Irving Tx
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
The right quarter panel was pushed out
The reader bumper was broken. Left lower quarter panel was pushed in/under
As you see where it was grinder it was also pushed in.
The reader bumper was broken. Left lower quarter panel was pushed in/under
As you see where it was grinder it was also pushed in.