Haltech Elite 1500 + Aquamist HFS-3?
Thread Starter
Full Member
Joined: Feb 2005
Posts: 182
Likes: 0
From: Sweden
Haltech Elite 1500 + Aquamist HFS-3?
Hi,
I'm wondering if the Haltech Elite 1500 can control the Aquamist HFS-3 water/meth injection system?
The HFS-3 require a IDC (Injector Duty Cycle) signal for operation.
Can the Elite output such signal through the DPO or DBV/DPO output?
In the manual for the HFS-3 it also says:
The system can also be controlled by a third-party ECU with its own custom water/methanol flow map.
Can the Elite control the HFS-3 this way?
It would be easier to configure a water/meth flow map in the Elite rather than turning diffrent ***** on the circuit board for the HFS-3.
Thank you.
I'm wondering if the Haltech Elite 1500 can control the Aquamist HFS-3 water/meth injection system?
The HFS-3 require a IDC (Injector Duty Cycle) signal for operation.
Can the Elite output such signal through the DPO or DBV/DPO output?
In the manual for the HFS-3 it also says:
The system can also be controlled by a third-party ECU with its own custom water/methanol flow map.
Can the Elite control the HFS-3 this way?
It would be easier to configure a water/meth flow map in the Elite rather than turning diffrent ***** on the circuit board for the HFS-3.
Thank you.
Thread
Thread Starter
Forum
Replies
Last Post
the_glass_man
Power FC Forum
2
May 28, 2010 12:33 PM