Ecu Pinout
#1
It wasn't me!!
Thread Starter
iTrader: (1)
Join Date: May 2004
Location: Cayman Islands
Posts: 1,189
Likes: 0
Received 0 Likes
on
0 Posts
Ecu Pinout
Well Guys, I'm trying to finish up my haltech install, which is taking forever. I have a slight problem of tapping the haltech connections into my wire harness due to having a 2000rs model. I can not find jack **** on the ecu pinout for this car. I can find everything else for the 1993-1995 rx7 but not for mine .
I am looking for the one wire that goes back to the ecu connector for the electric fans and the other wire for the a/c. Does anyone know how to tone the wires so that I can find the right one on the pin connector?
BTW, Can someone explain the a/c setup if I want to use the haltech to control it? I'm all over the place with that too.
And if by some mericle, does anyone have a scematic for the 2000 model rx?? That would help.LOL
Thanks guys, and BTW, I posted in here because I could get a striaght answer in the haltech forum, so admins, please don't move this thread unless you feel I will get better help in some other thread.
THANKS A BUNCH!!
<!-- / message --><!-- sig -->
I am looking for the one wire that goes back to the ecu connector for the electric fans and the other wire for the a/c. Does anyone know how to tone the wires so that I can find the right one on the pin connector?
BTW, Can someone explain the a/c setup if I want to use the haltech to control it? I'm all over the place with that too.
And if by some mericle, does anyone have a scematic for the 2000 model rx?? That would help.LOL
Thanks guys, and BTW, I posted in here because I could get a striaght answer in the haltech forum, so admins, please don't move this thread unless you feel I will get better help in some other thread.
THANKS A BUNCH!!
<!-- / message --><!-- sig -->
Thread
Thread Starter
Forum
Replies
Last Post
Erosangel
3rd Generation Specific (1993-2002)
5
09-18-15 04:06 PM
windom
Adaptronic Engine Mgmt - AUS
4
09-11-15 04:48 AM