Hello,

I was wondering how to connect and configure the TC-4 channels on a modular ecu. I have analog lambda controller and it seems that in eugene one can only get to see the serial in communications options when you select under wideband serial only. Which offcourse I cannot do as I would not have the analog lambda in anymore.

I use a ALM Can lambda controller with LSU ADV sensor. But afaik this can protocol is not yet supported?

BR

Ruben

 

Hi Ruben,

Sorry to hear you are having troubles! I can see how this setting can be a little confusing so I will explain. You will connect the Serial Out on the TC-4 with the 3846 cable then you will connect the other end to the IN1 on the adaptronic ECU. Then you will go to the Functions tab - Serial IN 1 - Drop down will be Innovate - Type - None - Number of MTXL, LC2, or LC1 Connected equals 0.

Since you are telling the ECU that there are no other devices you can read the note at the bottom that say "Note: Any other Channels are interpreted as TC4"


Innovate TC-4 Settings for Adaptronic with no serial wideband


Cheers,

Shawn Christenson
Tuned By Shawn