Adaptronic Monitoring Oil Pressure?
#1
Monitoring Oil Pressure?
I've read that the stock FD oil pressure sensor is wired directly to the cluster and doesn't go to the ECU
You guys with Adaptronic ECUs - do you have oil pressure in your logs?
If so, how did you do it? Stock sensor or aftermarket?
You guys with Adaptronic ECUs - do you have oil pressure in your logs?
If so, how did you do it? Stock sensor or aftermarket?
The following users liked this post:
mikey13b (02-06-24)
#4
Current plan is to use an AEM 30-2131-150 pressure sensor with an Autometer 2269 adapter so it fits into the stock location.
It's a 3 wire sensor.
Looks like the MAP sensor will be the easiest place to tap into for 5V power and sensor ground.
I can get +5V from the BR/W wire and signal ground from the B/LG wire. The other wire is the MAP signal (G/Y).
Then the sensor wire from the oil pressure sensor can go directly to the dedicated pin (1P) on the ECU.
Theoretically this should work well
It's a 3 wire sensor.
Looks like the MAP sensor will be the easiest place to tap into for 5V power and sensor ground.
I can get +5V from the BR/W wire and signal ground from the B/LG wire. The other wire is the MAP signal (G/Y).
Then the sensor wire from the oil pressure sensor can go directly to the dedicated pin (1P) on the ECU.
Theoretically this should work well
#5
Here is the sensor we use/sell;
https://turbosource.com/collections/...ensor-fuel-oil
this can be used for fuel or oil pressure.
Select models require the innovate SSI, modulars do not. We do carry the SSI its just not up on our website..
https://turbosource.com/collections/...ensor-fuel-oil
this can be used for fuel or oil pressure.
Select models require the innovate SSI, modulars do not. We do carry the SSI its just not up on our website..
Thread
Thread Starter
Forum
Replies
Last Post
Dannis
3rd Generation Specific (1993-2002)
3
05-05-03 07:33 AM
kevino
2nd Generation Specific (1986-1992)
1
10-28-02 07:06 PM
PraxRX7
2nd Generation Specific (1986-1992)
9
04-17-02 06:09 AM