I'm about to start a new project and I have something in mind, if not possible therefore turn to the Gurus Forum.

I just bought a Adaptronic 440 in conjunction with a board PLX Interface a Innovate LC2 and PLX DM100 Touch, is that all this is supported by the thread I've seen, but I want to add this: A Innovate SSI-4 (takeaway the sensor readings of water temperature, oil temperature and oil pressure going to my PLX DM100 cluster), I think removing my dash cluster and install a Dash2.

Will I be able to install this and you can see my readings in dash2 and others in the DM100?

That oil pressure sensors, water temperature and oil temperature recommended me to replace the originals to the original Dash?

Devil Mix : Adaptronic 440 - PLX Board Interface - Innovate LC-2 - PLX DM100 Touch - Innovate SSI-4 (new sensors : Temp water, Temp Oil, Pressure Oil) - Dash2

 

Hi mate, yes this is all possible.

The PLX board will take the input from the Innovate modules (SSI4 and LC2, and the TC4 EGT module if you choose to add it later) - and output to the DM100 PLX module. This connects to the ECU via the "serial in" port.

The "serial out" port then will connect to the Dash 2.

The only thing is that when you're talking to it with the laptop over USB, the ECU won't be able to output to the Dash 2, but during normal operation (ie not tuning) it will work.

Cheers!

 

thanks for the info, I'm on the right via.

Jonathan