RX7Club.com - Mazda RX7 Forum
Page 3 of 3
1
2
3
Show 50 post(s) from this thread on one page

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   Adaptronic Engine Mgmt - AUS (https://www.rx7club.com/adaptronic-engine-mgmt-aus-311/)
-   -   Adaptronic Acceleration Enrichment ID Injectors (https://www.rx7club.com/adaptronic-engine-mgmt-aus-311/acceleration-enrichment-id-injectors-1130588/)

mrselfdestruct1994 02-16-20 12:07 PM
There is also an article and a video on Adaptronic's website that has been available since the ecu was released.

slash128 02-17-20 11:32 AM
Originally Posted by mrselfdestruct1994 (Post 12395428)
There is also an article and a video on Adaptronic's website that has been available since the ecu was released.
Appreciate it. I have watched Andy's video and read the associated article. Since the discussion in this thread was newer I was curious to see if there were any additional bits of information.

Thank you.

Rub20B 02-22-20 03:06 PM
1 Attachment(s)
Just make sure you do not apply the rpm rate table as described in the tip. it will more the likely make for a very 'hairy' lambda signal :D

attached is a tune that now works surprisingly good on a car i am working on. rew engine xcsessive LIM, efr83, 550/ID2000, ..

slash128 02-23-20 10:55 AM
Originally Posted by Rub20B (Post 12396406)
Just make sure you do not apply the rpm rate table as described in the tip. it will more the likely make for a very 'hairy' lambda signal :D

attached is a tune that now works surprisingly good on a car i am working on. rew engine xcsessive LIM, efr83, 550/ID2000, ..
I will check it out, thanks!


All times are GMT -5. The time now is 04:02 PM.
Page 3 of 3
1
2
3
Show 50 post(s) from this thread on one page


© 2024 MH Sub I, LLC dba Internet Brands