Zeroing out Digital Boost Gauges?
Thread Starter
Below- "Esses" at RA
Joined: Dec 2001
Posts: 634
Likes: 0
From: Tampa Bay, FL area.....
Zeroing out Digital Boost Gauges?
Just installed my SPA dual boost/temp gauge. I have very few mods, yet it's reading (spiking?) up to 14psi, which I find hard to believe.
The manual talks about zeroing the gauge, but it is a bit confusing. Anyone got any tips on this, such as when you zero it I presume that's with the engine off? Also, it does averaging and the time frame in which it "averages" can be programmed as well. The default was .4 seconds; does anyone have any ideas on this?
Any help gets the sender an automatic
TIA.
David
The manual talks about zeroing the gauge, but it is a bit confusing. Anyone got any tips on this, such as when you zero it I presume that's with the engine off? Also, it does averaging and the time frame in which it "averages" can be programmed as well. The default was .4 seconds; does anyone have any ideas on this?
Any help gets the sender an automatic
TIA.
David
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
Mar 15, 2022 12:04 PM
