wiring harness...help!
#1
Rotary Enthusiast
Thread Starter
wiring harness...help!
Well, putting my FD back together...and while moving the wiring harness to install the fuel rail broke a wire right at the connector.
FOCK!
Anyway, I beleive the wire is to the knock sensor. It is a one wire clip...the one from the large harness that broke.
I cannot insert another wire into the clip cause it broke right at the connector. Can I just terminate the wire by cuttin the other clip and butt connecting them or using male/female crimp connector for future separation?
thanks
FOCK!
Anyway, I beleive the wire is to the knock sensor. It is a one wire clip...the one from the large harness that broke.
I cannot insert another wire into the clip cause it broke right at the connector. Can I just terminate the wire by cuttin the other clip and butt connecting them or using male/female crimp connector for future separation?
thanks
#4
Rotary Enthusiast
Thread Starter
thank you duboisr...that is what I did.
man, doing all the work yourself is rewarding (if it starts) but very tough...this forum has been soooo helpful.
thanks again.
man, doing all the work yourself is rewarding (if it starts) but very tough...this forum has been soooo helpful.
thanks again.
Thread
Thread Starter
Forum
Replies
Last Post
toplessFC3Sman
2nd Generation Specific (1986-1992)
6
03-20-18 01:54 PM