Wire snapped and I need help with where it goes.
11-09-06, 07:23 PM
#1
I swear I didn't know.
Thread Starter
iTrader: (2)
Join Date: Jul 2004
Location: Vic's Mom's House
Posts: 580
Likes: 0
Received 0 Likes
on
0 Posts
Wire snapped and I need help with where it goes.
I have this wire snap when I was changing my Front Rotors Trailing spark plug.
It is Blue with a solid yellow stripe. It comes from the harness to a plug and out to a small boot. It goes to a sensor. When It snapped my CEL came on and when I switch gears the rpm's jump 2,000 and don't come down until I switch gears.
I have the CEL codes 12, 18, 40!
Here is a pic of it. It is underneath the Intercooler Elbow, next to the oil dipstick. It goes somewhere underneath the Intercooler piping to the TB. but to where I don't know after that.
Wire that snapped is a Blue with a solid Yellow Stripe comming off of the harness and into a plug. The plugs wire is black and the wire goes somewhere where the Front Rotor, Trailing Spark plug is and up over the engine in that direction I think.....
Any thoughts?
It is Blue with a solid yellow stripe. It comes from the harness to a plug and out to a small boot. It goes to a sensor. When It snapped my CEL came on and when I switch gears the rpm's jump 2,000 and don't come down until I switch gears.
I have the CEL codes 12, 18, 40!
Here is a pic of it. It is underneath the Intercooler Elbow, next to the oil dipstick. It goes somewhere underneath the Intercooler piping to the TB. but to where I don't know after that.
Wire that snapped is a Blue with a solid Yellow Stripe comming off of the harness and into a plug. The plugs wire is black and the wire goes somewhere where the Front Rotor, Trailing Spark plug is and up over the engine in that direction I think.....
Any thoughts?
Thread
Thread Starter
Forum
Replies
Last Post
toplessFC3Sman
2nd Generation Specific (1986-1992)
6
03-20-18 01:54 PM