hey. it's been quite a few months since when i pulled the harness. i can't remember if the harness section that goes to omp and Crank angle sensors go between the water housing and block, in that gap . or on the outisde. if you need a pix i can take one. if ya'll could help me out on this detail i'd apprecaite it. Thanks!


Los

 

See if this helps:

https://www.rx7club.com/3rd-generation-specific-1993-2002-16/wiring-harness-routing-531829/

 

kick ***. helped me out with hor to route the cas wires, BUT i still can't tell if the omp harness side goes in taht gap or stays outside of water pump housing or goes between block and housing. thanks mahjik!!!


Los

 

Are you talking about the ECU wires for the OMP? If so, they usually route under the waterpump housing (overtop the main pulley) along with the OMP oil lines.

 

that's what i was talking about.... damn. that means i gotta remove the damn water housing again. ok. thanks for the help.

Admin can close thread if need be.


Los
Thanks Mahjik again for the help.

 

You might be able to see a little in the pictures in the following thread:

https://www.rx7club.com/3rd-generation-specific-1993-2002-16/help-big-problem-im-idiot-421227/