why does my coolant sit so low?
#1
Rotary Enthusiast
Thread Starter
why does my coolant sit so low?
when the engine is stone cold, and i try to add in more coolant, the coolant would just drain back to the very bottom of the filler neck, i can never get it to stay topped off all the extra water/coolant i put in goes to the overflow tank... wat is wrong with my coolant system?
the overflow tank is full, new cap on the filler neck, and new stan pressure release 16lb cap on the alumnium ast.
any ideas guys? is coolant level suppose to stay at the very top in fd?
thanks,
Randy
the overflow tank is full, new cap on the filler neck, and new stan pressure release 16lb cap on the alumnium ast.
any ideas guys? is coolant level suppose to stay at the very top in fd?
thanks,
Randy
Thread
Thread Starter
Forum
Replies
Last Post
rotor_veux
2nd Generation Specific (1986-1992)
7
08-31-15 07:49 PM
RPOdesign
New Member RX-7 Technical
5
08-27-15 11:42 PM