Finally decided to get off my butt and clean up my non-seq conversion. I pulled off the UIM and ripped out the rats nest. I'm trying to clean up the engine and remove all the unneeded stuff; vacuum lines, solenoids, installing block-off plates, etc. Its been 4 years since I did the conversion. I was in a rush back then so I left most of the stock stuff in place. I took some pix of the engine and wanted to see if anyone had the same oil leak problem and point me in the right direction to correct it.

http://members.***.net/roadrkt/DSC00027.jpg

http://members.***.net/roadrkt/DSC00028.jpg

http://members.***.net/roadrkt/DSC00029.jpg

Any help much appreciated. Any other suggestions of things to do while I have access?

-KPM

 

Might be the O-ring on the oil filler pipe mounting flange.