3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

Where (if at all) does this plug go?

Old Aug 22, 2004 | 10:22 AM
  #1  
bajaman's Avatar
Thread Starter
Constant threat
Tenured Member 20 Years
 
Joined: Jul 2001
Posts: 4,968
Likes: 39
From: near Wichita, Kansas
Where (if at all) does this plug go?

Whilst labeling all the various plugs that fit into the UIM, I came across THIS one that I just don't think was ever used. It is a black plug with a yellow center. It has 3 female prongs on the tab with a flat side. It is part of the wiring harness that has the ground wire loop right on the rear of the UIM. Am I right in assuming it is just an unused plug?


Reply
Old Aug 22, 2004 | 10:28 AM
  #2  
paw140's Avatar
Rotary Freak
Tenured Member 05 Years
 
Joined: Dec 2001
Posts: 1,668
Likes: 0
From: Hattiesburg, MS
I don't recall having any unused plugs in the 1/2 dozen times I've had the UIM off...
Reply
Old Aug 22, 2004 | 10:28 AM
  #3  
MR_Rick's Avatar
Planning my come back
Tenured Member 20 Years
iTrader: (7)
 
Joined: Feb 2003
Posts: 3,393
Likes: 0
From: Austin, Tx
I think it goes to the O2 sensor but not sure. If not and you got block off plates then it probably ain't in use.
Reply
Old Aug 22, 2004 | 10:29 AM
  #4  
paw140's Avatar
Rotary Freak
Tenured Member 05 Years
 
Joined: Dec 2001
Posts: 1,668
Likes: 0
From: Hattiesburg, MS
Are you sure it's not for the idle speed controller or air temp sensor, or one of those other sensors on the back of the UIM?
Reply
Old Aug 22, 2004 | 10:33 AM
  #5  
bajaman's Avatar
Thread Starter
Constant threat
Tenured Member 20 Years
 
Joined: Jul 2001
Posts: 4,968
Likes: 39
From: near Wichita, Kansas
Originally Posted by hondasr4kids
I think it goes to the O2 sensor but not sure. If not and you got block off plates then it probably ain't in use.
Damn! That's IT! Thanks, that was driving me crazy!
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
wretchedegg
General Rotary Tech Support
1
Nov 19, 2025 03:07 AM
HalifaxFD
Canadian Forum
126
May 9, 2016 07:06 PM
betes
1st Generation Specific (1979-1985)
8
Sep 27, 2015 08:25 AM
ZacMan
Build Threads
4
Sep 19, 2015 09:20 PM
Enzo1944
New Member RX-7 Technical
2
Sep 6, 2015 08:57 AM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 06:04 PM.