af908

Well ..does anyone know where i can find the plastic piece ive seen some of you use to hold 3 gauges underneath the radio head unit?? Can't seem to find one anywhere...

JimmyJimboJet

https://www.rx7club.com/forum/showth...saab+din+panel

7 posts down on the first page.
note the changed part number...

Mazdabation

iTrader: (9)

If I'm not mistaken, the Saab gauge panel has been discontinued.
So with this, what is the next best gauge holder??

reza

check out http://www.omori-na.com

They have flat style DIN mount and staggered style DIN mount.

I think they are on Products --> Accesories.

Reza

adam c

iTrader: (2)

I bought mine at www.egauges.com

It was $25. I tried to find a Saab panel with no luck.

Adam

af908

adam c : where is the panel on the site you gave me? I can find it.

adam c

iTrader: (2)

It may not be on the website.

Call them (Don's Sport Vehicles) at 800-303-6211
The part # is vpw0041
It is listed as an MK4 gauge panel

I might have a pic somewhere. Send me your e-mail address, and I will send it if I can find it.

Adam

meddle

I got one less than a year ago, it was only like 7 bucks

adam c

iTrader: (2)

The Saab panel did not come stock on their cars. It was a factory upgrade item that you could get from Saab. Not that many people bought them. They have been discontinued for quite some time. Almost impossible to find one these days. I looked.

af908

adam c... is this it? http://www.egauges.com/vdo_acce.asp?Subgroup=MK4_DIN

Do i need the U Bracket?

skunks

make your own out of CF, its easy

Here is the black on black twill



How about some red carbon/kevlar


how about replace them both...






(and yeah i know the twill is not that straight on this last one, but i though he was gonna just gonna cut the carbon to fit a single din pannel and that he would have avoided the wavy part and used it to practice or something)

I'll send ya another peice if you want quad, but you gotta pay me shipping

adam c

iTrader: (2)

Yes, this is the right part. I bought 2 spin lock gauges. They hold the 3 hole panel in place. My center gauge is my boost gauge. I just put some tape around the gauge until it fit snugly in the bracket. It stays in place, and can be removed easily to access the spin locks to remove the other two gauges. This way I dont have to remove any of my dash to remove the guages.

I'll e mail you a pic tomorrow.

Adam

af908

i still don't understand, what is the difference between spin lock and ubracket? I bought three autometer ultra lights. what do i need, u bracket or spin lock?

adam c

iTrader: (2)

Each gauge has a way of holding it in place. A spin lock gauge has threads on the back of the gauge on the outside. There is a large cylindrical plastic piece that screws on the back and acts as a clamp to hold the gauge in place. A u-bracket normally screws on a center screw on the back of the gauge.

Your guages should have mounting instructions.