So I'm about to rip out my entire suspension replacing all bushings with SuperPro's as well as installing Stance Gr+ Coilovers.

I noticed that the front coilovers dont have a bracket welded to them for the brake line to sit in. Now it seems that without it, the brake line would bounce around a lot causing stress to the hardline attachments and at the caliper.

Does anyone know where I can find something like what is pictured below?
Stance's instructions and website don't seem to say anything about it?

 

You could just get some large and small hose clamps or a large hose clamp and a good ziptie or two. Large clamp around shock housing and small clamp or zip underneath said clamp and around brake line.

 

I actually had thought of that cal1mr, I was just hoping for something more substantial like what is in the picture...if push comes to shove I'll use hose clamps though.

 

Few minutes with Google came up with this:

http://www.speedwaymotors.com/Remova...DisplayId=1973

And these:

http://www.jcwhitney.com/billet-brak...44&zmap=25361G

I really like these pieces. I would think they would fit around the Shock.

They have them in Anodized too:

http://www.jcwhitney.com/brake-line-.../p2015356.jcwx